4 Common Dumbbell Lateral Raise Mistakes !
When you were younger, you probably had a wish list for Santa. Now that
you're a big boy, I bet that list includes new things like bigger pecs, an
inch on your arms, or wider shoulder caps.
Bigger delts are high on every trainer's list because they create the
illusion of a smaller waist, improve the visual delineation from the upper
arm, and add the kind of cap that says you're a serious lifter. That little
extra stretch in your shirts? That's what I'm talking about!
Like a lot of lifters, you might be starting your shoulder workout with
overhead presses. That works. But adding lateral-raise movements is the best
way to isolate the middle delts in the lateral (side) plane.
The lateral raise is popular. So is blowing the technique, often in more
ways than one. Here are seven ways to screw up the most common variation,
the standing dumbbell lateral raise.
Blunder 1: Changing Your Elbow Bend During The Movement
To do a lateral raise correctly, you create a very slight bend in your
elbows, then maintain that same degree of bend throughout the set. The angle
in your elbows at both the bottom of the rep should be the same it is at the
top.
If you start opening and closing at the elbows, you're bringing the triceps
into the equation, undermining the middle-delt isolation you're trying to
achieve. Ideally, as you raise the weights, they should follow more of an
arc than a straight line. Watch yourself, or have someone watch you as you
do this move; this blunder isn't hard to correct if you're paying
attention.
Blunder 2: Lowering The Weight Too Far
The best way to build these target muscles is to maintain tension on the
middle delt throughout each rep. If you bring your hand all the way down so
that it's hanging by your side or in front of your thigh, you're not putting
any tension on your delt at all.
What's more, when you start lifting from this fully extended position, the
supraspinatus (a rotator-cuff muscle) initiates the movement before the
middle delt head kicks in. That means the first few degrees of your lift
aren't working your target muscles.
Your best bet is to stop the movement with your hand several inches from
your side. This will make lifting the weight back up a little harder, which
is what you want, right? If you do want to work your supraspinatus a bit,
then go ahead and lower the weight all the way. But when you lift it again,
be careful not to use too much weight or make jerky motions, both of which
can lead to injury.
Blunder 3: Dropping Your Elbows
A common mistake among beginners is to wave the weights up and down without
raising their elbows out to their sides. In that sense, the upper arms don't
go through much of a range of motion, which can kill your middle-delt gains.
That's why you always want to "lead with your elbows" so they go through the
full ROM.
When your elbows don't move much, you essentially negate the benefits of
this middle-delt movement. Even though your hand is where it should be at
the top, your elbows are still only about halfway up. Note to self: Always
lead with your elbows.
Blunder 4: Stopping The Motion At Shoulder Height
People usually do lateral raises to about shoulder height, even though the
middle delt's range of motion extends further overhead. By continuing up to
about 45 degrees above parallel, you can get a bit more contraction out of
your middle delts. (You'll also engage your upper traps a bit.)
When you extend your range of motion above your shoulders, you'll probably
have to back off on weight. You might consider a few heavier sets to
shoulder level, followed by a few more with a slightly lighter weight taken
about 45 degrees above parallel.
If you have shoulder impingement or pain, it's probably not a good idea to
lift above your shoulders. If this is an issue, talk with a sports-medicine
doctor before trying to extend your ROM.
Blunder 5: Locking Your Arms So They're Completely Extended
Occasionally, you'll see someone doing lateral raises with their arms
locked out to full extension. At the top of the movement, it looks like the
person is trying to form the letter T. This full extension puts a heckuva
lot of pressure on the elbow joints. Whatever exercise you're doing, it's
never a good idea to lock out a joint.
Blunder 6: Locking An L-Bend In Your Elbows
It is a common fallacy that you can lift more weight in a lateral raise if
you put a big bend in your elbows (approaching 90 degrees) instead of a
slight bend. Yes, you can add more weight, and, yes, your upper arm will go
through the same range of motion. But...
The "lever arm" concept in physics essentially means that the further away
from your body a weight is, the harder that weight is to lift. Let's say
you've been doing lateral raises with your arms almost fully extended and
can lift 35 pounds. Then you start doing the raises with your arms bent at
90 degrees, and lo and behold, you can lift a lot more!
If you think that extra weight means you're getting stronger, just try
straightening your arms a bit more. Can you still do your reps with that
weight? Probably not. That's the lever-arm law of physics hard at
work.
Blunder 7: Don't Ever Call Them "Medial" Delts
It's not unusual to hear people refer to their "medial" delts. There is no
such thing. The correct word is "middle" delts. If you want to know the
correct name—and want to sound like you know what you're talking about
around the gym—stick to real names.
